C-W2 Duplex Pump Controller

C-W2 Duplex Pump Controller

Double pump controller

C3 - W2 C1 - W2

Main characteristics:

Rated input voltage:

C3 - W2 AC380V/50HZ, three-phase

C1 - W2 AC220V / 50HZ, single-phase

Rated output power:

C3 - W2 0.75KW - 4KW (1hp - 5.5 hp) 5.5 KW - 7.5 KW (7.5 hp - 10hp) 11KW (15hp) 15KW (20hp)

C1 - W2 0.37KW - 2.2KW (0.5hp - 3hp)

Protection function:

◆ Protection against dry operations without sensors

◆ Overload protection

◆ Low/over voltage protection

◆ Phase protection

◆ Leakage protection (adjustable)

◆ engine stall protection

◆ Phase imbalance protection *

◆ Phase inversion protection *

◆ Overheat protection *

Key Features:

◆ Control characteristics: pulse electrodes probes / float switches / electrical contacts pressure gauges / pressure switches

◆Features: HD liquid crystal dynamic English

◆Control mode: manual/automatic, double pump automatic alternation, fault automatic switching

◆ Standard parameters for full protection in manual / automatic mode

◆ Five recent pump failures.

◆ Show the total operating time of the pump

◆ anti-corrosion protection of the pump shaft

◆ scintillation command in the opposite direction of the probe line

◆ Fast water supply when power is cut off or restored

◆ Status setting

◆ Remote monitor optional (SC2)

◆ Liquid level sensor transmission distance is 1000m

◆ Fault warning

◆ Remote network port

◆ Calibration button

◆ Drain alarm

Protection class: IP54

Typical application example

Double pump controller for: